Paste the filler not discharging at work, how to operate?
For each device, would be able to finish the work is very important for production, and in the production of paste filling machine, is particularly important step is cutting and filling, if the device does not discharge problems at work, which is fatal problem, the whole production cannot proceed, so users have to know when to paste filling machine when this happens, how to do it? Expensive, xing on this question have the following conclusion:
Paste filling machine will figure
Troubleshooting:
1, first check whether the hopper and product, not to add, please note: within the hopper goods should not be less than one over ten, less than one over ten to continue filling, will affect the accuracy of the filling.
2, to check whether there is jam filling filling the tank, congestion is divided into two kinds: first, the good filling machine in the last, placed for a long time without cleaning, and lead to the inside of the tank product solidified, blocking the tank, the second, the product of sundry, stuck in the tank on the pistons, lead to bad sealing effect, appear the above two cases, please clean up in time, so as not to damage the piston.
3, the above two cases still cannot solve the problem, which is the tank (below the hopper to send products to filling the part of the mouth called bladder) on the piston ring has been damaged, please replace.
Operational guidelines for school official cites use:
1. Before use, first wash clean hopper, add product (that is, you need to filling paste liquid)
2, after joining products, hand control causes the product pressure until out of the mouth filling properly.
3, the product can normal, adjust the volume of filling in the beginning, below the hopper there is a ceramic pump, a regulating screw at the bottom of the fuselage, you need to debug the filling amount, which can start to work.
About hubei expensive diagnostic reagents of hing intelligent technology co., LTD, filling machine, paste filling machine, liquid filling machine for more information, please contact us!
